Small Cap allows for easy fire wall clearance, especially for Pre-1975 that do may not have the room for a large size HEI. OEM appearance (also available with female cap). Unit is fully CNC machined. Fully self-contained distributor with built in Module.Only requires 12 volt External coil for electronic ignition (Typical points coil will not work). No Ballast Resistor is required. Easy two wire Hookup (wires included). Same as late GM HEIs except you run an external coil instead of In-cap coil. Eliminates the need for all the extra wiring and ballast resistor. Major improvement in starting and performance over points. Spark plug gap can run from around 40-45 instead of 35 if you run points. Same size as the original points distributors and is fully electronic. Far less pollution, as the fuel is burned much better. Faster start ups, especially in cold weather. Those with carburetors prone to flooding will notice a huge difference, as the spark on electronic ignition is many times stronger than point style ignition. Virtually no maintenance, compared to points. Spark plug life is 3-5 times longer, as well as plug wires. Much better performance, over points, mostly due to the better combustion of unleaded fuel, as this was the primary reason for the development of electronic ignition. Point dwell changes as points wear out, causing your timing to advance dramatically. This brings your engine much closer to detonation, not to mention hard starting, and poor performance.
Over all engine life is much longer with electronic ignition over points. This listing also includes a New RED 12 Volt coil that puts out 45,000 volts.This coil has the classic "old Skool" look and is oil-filled. This is a perfect coil to run with this electronic distributor. Secondary resistance: 4.5K OHMs. Maximum voltage: 45,000 Volts. Alkyd tower with high dielectric properties is less prone to carbon tracking.
100:1 turns ratio and lower primary resistance produce high voltage output. Metal canister is filled with a premium grade oil for cooling. 8.5 mm SPIRAL CORE SPARK PLUG WIRES MADE IN THE USA BY BLOCK PERFORMANCE PARTS (BPP)! This listing includes a set of High Performance 8.5 mm RED Spiral Core Spark Plug Wires made in the USA by BLOCK PERFORMANCE PARTS.
The wires are already factory assembled on both ends for the SMALL BLOCK FORD 221, 260, 289 & 302 ENGINES WITH THE HEI STYLE /MALE DISTRIBUTOR CAP. Spiral core is the best of both worlds because it gives you high performance without any interference on your radio and electronics. These spiral core wires produce higher performance through improved efficiency, quicker throttle response, and reduced emissions. The BPP 350 Spark Plug Wires are a 3 layer, 60,000 volt high voltage ignition wire. The 8.5mm diameter cable provides an increased capacitance value of 20% over 8mm sized wire.
First coat is an epdm high dielectric strength inner layer. This provides the initial capacitance values to ensure the high voltage current does not ground out through the jacket. The fiberglass matting is extruded over the EPDM as a dual purpose layer. It virtually eliminates terminal pull off and bonds the inner EPDM first coat to the silicone outer jacket. Stainless steel and solid brass terminals are used to maintain the conductivity and high voltage current flow between the voltage source and spark plugs.Our ultra high temperature grey silicone spark plug boots are rated at a radiant temperature of 800 degrees. The high dielectric strength distributor and coil boots eliminate voltage leak through. With all of the highest quality materials used in our BPP350 wire sets, you can be assures you are purchasing one of the finest quality ignition wire sets in the market. The gray spark plug boots are high heat boots that can withstand 50 degrees more heat than standard spark plug boots! 2 coil wires are also included! Next, choose a topic from the list provided. Some common questions and answers may be shown. We are a family business and your satisfaction is critical to our success. Your questions are answered by owners of the company.
All descriptions are provided accurately to the best of our knowledge. While all care is taken, any errors or omissions in the item details are unintentional.
We are not mechanics but will assist you to the best of our abilities (or forward you to one of our support representatives). These charges are the buyers responsibility. We cannot mark merchandise values below value or mark items as gifts US and International Government regulations prohibit such behavior. Any product which has been altered in any way, improperly installed, or not used for its intended purpose.
Any costs associated with the repair or replacement of the product including labor, installation or other costs incurred by the purchaser, and in particular, any costs relating to the removal or replacement of any product that is affixed to another devise. Any damage to the product due to external causes, including accident, problems with electrical power, abnormal electrical, mechanical or environmental conditions, usage not in accordance with product instructions, misuse, neglect, alteration, repair, improper installation or improper testing.
The item "FORD 289 302 SMALL CAP HEI DISTRIBUTOR + COIL + 8.5mm RED SPARK PLUG WIRES" is in sale since Sunday, March 10, 2019. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Ignition Systems\Distributors & Parts". The seller is "blockperformanceparts" and is located in Barnegat, New Jersey. This item can be shipped worldwide.