Around 360 panoramic parking is through the installed in the front and rear of 4 ultra wide Angle fish-eye camera collection vehicles around the image at the same time, through the synthesis unit; image distortion correction algorithm, splicing and fusion, form a picture of a vehicle around 360 degrees of 2d and 3d panorama, real-time transmission to the central screen, make the driver by the surrounding environment display can visualize body on the ground there is no perspective blind area, can help the driver to confirm whether there is any obstacles around the vehicle clearly; help the driver to easily deal with complex surfaces and parked vehicles. The product is simple to install, stable and reliable. Boot around, the surrounding situation is clear.Supports 2D panorama, 3D panorama, single camera hill-screen display off and open and other combined display modes. Support AHD, CVBS, VGA and other output interface signal formats. Support full automatic one-key calibration without manual adjustment, seamless splicing and no blind spot on the ground. 4-channel video real-time driving record, local playback. Four-channel AHD hd signal input, clear and smooth picture quality.
Narrow road real-time road conditions, driving safer. OSD menu for IR remote control. Video Input: 4-ch video input. Effective Pixels:1280(H)960(V) Video.Display Mode: Single frame/three frame/four frame display and 3D Image. Recording Mode: Automatical recording/detect recording/manual recording. Recording Channel: 4 channels (1-4 channels optional).
Data Storage: Support 4G32GB SD card. Software Upgrade: Support SD upgrade. The relevant interfaces of the host and main bundle are as follows. Power connection: connect power supply (yellow wire to normal power; red wire to ACC, black wire to ground) 2. Red lines on the extension cord: connect the positive pole of the left and right turn signal and the reversing light respectively 3.
Black BMW joint: connect to the front camera 4. Yellow BMW joint connect to rear camera 5. Red BMW connector: connect to the left camera 6. Blue BMW connector: connect to the right camera 7.
Yellow AV interface: host video CVBS output interface, which is connected to CVBS reversing video channel display through video extension cord 8. Blue AV interface: the host video AHD output interface is connected to the central AHD reversing video channel display through the video extension cord 9. Brown DVD trigger line: connect the navigation and reversing detection line 10.Yellow RF antenna, receiving knob controller signal 11.6PIN interface: VGA video output interface of the host, connect to the VGA decoder; and connect to the original vehicle screen through the decoder (original vehicle support is required) 12. USB interface: connect the U disk, which can be used for driving record, system upgrade and parameter storage 13.
OBD/CAN interface: some models are inserted into the original vehicle OBD, and some models are connected to gateway or host CAN line. Specifically according to the system setting - setting of the model menu prompt 14. Indicator light the flashing red light of the host machine means it is working normally^ while the flashing green light means it can receive the signal of the controller Operate the controller with no flashing green light Please check whether the controller is installed with batteries or paired successfully. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts & Accessories\Exterior Parts & Accessories\Body Moldings & Trims". The seller is "daynight_2028" and is located in this country: CN.
This item can be shipped worldwide.