Dna T3/t4 T3t4 T04e. 63 A/r Turbine 5 Bolt Flange Turbocharger Turbo Charger

  

63 A/R TURBINE 5 BOLT FLANGE TURBOCHARGER TURBO CHARGER. This T3/T4 hybrid turbocharger assembly is created by installing a T4 compressor wheel and housing onto a T3 turbine housing, wheel and center section.

A T3/T4 hybrid turbocharger assembly is a compromise for engines where a T3 turbocharger is too small to reach the desired maximum horsepower but using a T4 turbocharger would create an unacceptable amount of turbo lag. The T3/T4 turbocharger is designed to be used on engines displacing 1.6L-2.5L and is typically good for around 400HP.

They are also commonly used in twin turbo applications. In this case those figures would be doubled 3.2L-5.0L engines up to 800HP.

Horsepower ratings are generally meant to express the turbochargers maximum airflow capability. Recommended boost pressures are 7psi. 5 Bar to 21psi(1.5 Bar) and boost pressures should not exceed 30psi(2 Bar). Exceeding 21psi(1.5 Bar) of boost pressure can significantly reduce a turbochargers lifespan. Generally speaking 14psi(1 Bar) is good for a 100% increase in horsepower from a naturally aspirated engine. Also factory non-turbo engines without forged internal components on high octane pump gas (91-92 octane) it is not recommended exceeding 7psi. Doing so could result in damaging your engine. Capable of boosting horse power up to 300+ BHP. High quality material, cast housing with durable steel. Standard T3 5 bolt downpipe flange pattern. Intake inlet & outlet: 3" & 2" Compressor. Additional parts will be needed to complete install. Please consult professional turbo installer for details.

We'd love to hear from you! We stand behind the products we sell. Please inspect all your order(s) upon receipt.

All items are brand new unless otherwise stated. PROFESSIONAL installation is highly recommended.

The item "DNA T3/T4 T3T4 T04E. 63 A/R TURBINE 5 BOLT FLANGE TURBOCHARGER TURBO CHARGER" is in sale since Wednesday, November 02, 2011. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Turbos, Nitrous, Superchargers\Turbo Chargers & Parts".

The seller is "dptmotorsport" and is located in Rowland Heights, California. This item can be shipped worldwide.

• Brand: DPT Motorsports
• Manufacturer Part Number: DPT-TBCT04E63
• Materials: Cast Iron/Steel Turbo Housing/ Aluminum Controller
• Placement on Vehicle: Front,Rear,Left,Right
• Surface Finish: Cast
• UPC: DOES NOT APPLY
• Intake Inlet/ Outlet: 3.00"/ 2.00"
• Inlet / Outlet Diameter: 3" / 2"
• Compressor A/R: 0.5
• Compressor Inducer /Exducer (MM): 50.50 / 76.00
• Compressor Trim: 55
• Exhaust (Downpipe) Flange: Standard T3 5-Bolt
• Exhaust (Turbo Manifold) Flange: Standard T3/ T4 4-Bolt
• Turbine A/R: 0.63
• Turbine Inducer / Exducer (mm): 65.50 / 55.90
• Turbine Trim: 73
• Fitment Type: Performance/Custom